When I parked our Buick wagon awhile back, there were no visable leaks - oil or coolant. Several weeks after it was parked, I noticed a good sized puddle of transmission fluid under the car as if it had dumped out seveal liters of oil. This happened almost literally overnight - it was not a puddle of oil that slowly grew. One day there was no sign of it - the next day there was a mess. Hmmmmm.. I was bummed out but since the transmission needed replacing anyways, I wasn't all that bothered.
Then about a month ago, I pulled our old '77 Ford Super Cab into the shop to revive it after it had been sitting for a few years. The transmission had leaked a bit where it was sitting but not a lot, given the length of time since the truck had last moved which was several years. I drove it into the shop where it has been sitting for the last month or so while I am going through the brakes , replacing the cab corners and getting it ready for repaint. There were no leaks under the truck for the first several weeks and then I noticed a few drops of transmission oil under the truck at the front of the transmission. The next day when I came out to the shop, the transmission had puked out several liters of fluid to the point where the oil had run out from under the truck across the shop floor and the spill extended several feet past the side of the truck. The leakage is at the front of the transmssion - any ideas why this has happened? Is it the front seal and if it is, why did it take so long to leak and then leak at such a rapid rate? Any help will be appreciated. Thanks. Gary
Just a thought but on the Ford, I think some have a drain plug in the converter that could piss itself if loose or other problems.. Also if it has the drain plug and someone didn't line the plug up w/ the relief hole in the flex plate, it could have taken time of being pressed against the plate to leak?. Without adding juice, what's the level at?. And when you start the truck and pop it into gear does it slip right away like the converter is empty?. And is it finished leaking the way it sits now but if you do the reverse/drive thing at idle to suck fluid into the converter, does it piss itself again?.
Good luck!.
__________________
I like real cars best...especially the REAL real ones! ----------------------------------------------------------------
Just a thought but on the Ford, I think some have a drain plug in the converter that could piss itself if loose or other problems.. Also if it has the drain plug and someone didn't line the plug up w/ the relief hole in the flex plate, it could have taken time of being pressed against the plate to leak?. Without adding juice, what's the level at?. And when you start the truck and pop it into gear does it slip right away like the converter is empty?. And is it finished leaking the way it sits now but if you do the reverse/drive thing at idle to suck fluid into the converter, does it piss itself again?.
Good luck!.
Thanks for the input. I have never seen a drain plug on the converter for C6 transmissions in that era of truck so I am thinking that the problem is not related to that. Besides, our Buick wagon with a Turbo 350 did pretty much exactly the same thing. I'll get under the truck today and see if I can determine for sure where the oil is coming from - I know that it is the front of the transmission but I'll see what I can see. I sure do hope that I don't have to pull that transmission and replace the front seal. *sighs* I hate transmission work.
-- Edited by GC on Thursday 11th of June 2009 04:09:23 PM
I had a 69 Nova, that I had put a 400 turbo in It would puke out "gallons" of fluid, while it was parked for winter.. I would fill it up, and it would not drip a drop all summer ?????
I used to sell a GM product called ATC way back in the GM days. This product was a seal swell and transmission rejouvenator. A lot of the problems with automatics is the heat and clutch packs really take the toll on the fluids. They break down and then the seals all harden and you have problems everywhere. Remember to change out the fluid every now and then and if not add some of the ATC if its still available ?? Even the dipstick tube has a seal on it and a lot of fluid can puke out of that little seal leaking as was the problem similar on my sons El Camino. There is a nice tube changeup with a lip seal that makes a huge difference there too.
Elroy, So is the culpret the front input shaft seal then?? If so, then it dounds like it needs to be changed which means pulling the automatic. Again, I say - to that job. *sighs* I am thinking that if this is indeed the case then it is because the torque converter has drained back into the transmission body... aww YUK!Please tell me I am wrong... *sighs*
I haven't heard of using brake fluid before but it stands to reason that it will soften and swell the seals up.
The thing that I don't understand is why the transmission didn't leak for a number of days and then suddenly the fluid puked out overnight. Usually a seal will leak and grow progressively worse over time where as this happened literally overnight on not one but on two vehicles. The Buick wagon had a slow leak and we put a quart of Lucus Transmission additive in and the leak stopped right away - until we parked it. Then, like the Super Cab, there was no leakage for days and then again, literally in a very short few hours, there was transmission oil all over the cement pad under the car - just like the Ford. I hate automatic transmissions - leaking, dripping, drooling, slobbering things that they are.
Agree. If it's been laid up for a while it's probably the front seal. While my Pontoac was in the shop for body & paint, it started to leak badly. I had to pull the trans as soon as it came home, to replace the seal on the front input shaft. Not a drop since.
Well, I just talked to a local man here who is one of thebest mechanics in the area. He's hard to get in touch with but I did manage to talk to him this evening. He says it's most likely the torque converter seal. Apparently when an engine and transmission sit for too long, the seal dries out and then it can tear when the engine is started. It still doesn't explain why it took two weeks for the fluid to suddenly decide to pour out - maybe some things are just better off not thought about. He said that an agent to cause the seals to swell is only a temporary fix so I guess I'll be pulling a C6 in the not too distant future. He suggested that with some things, it is best to just bite the bullet and fix it properly. I tend to agree. Thanks for the input guys... I really appreciate it.
I have seen this a few times and my own experience has been it's the filler tube seal. You should be able to see on the Buick at least if that's what it is by looking under with a trouble light. It should have run down the side of the case and over the lip the pan sits against. Not sure if the Fords do it but I've had it and so have a few others I know who store cars. I am told it's because the torque converter drains down slowly when parked for extended periods and the level gets higher than normal in the pan.
Not to say it can't be the converter seal but I've normally seen them leak out only when the trans gets hot, such as when pulling a trailer or working a trans hard while stuck.
__________________
1966 Strato Chief 2 door, 427 4 speed, 45,000 original miles
1966 Grande Parisienne, 396 1 of 23 factory air cars
I havent seen a torn seal yet but they get hard and dryout. The front pump outer seal goes too, but I would really check the dipstick tube seal and the kickdown cable seal and the connectors for the cooler. All this stuff can leak and you can change the tranny out and it still leaks. The dipstick tube can leak and still run into the underpan too. So take some rags, clean it up good and run it and check for leaks closely with the underpan off . Only then can you tell if its the front seal . For units that are sitting, run em hard and get it good and warm and it might stop leaking for a while. Just sitting is the toughest on seals Find some conditioner, its probably solvent as that stuff swells seals quicker than you know what.
I'll be more than happy to crawl under the truck in the morning and check out the filler tube - I REALLY hope thatyou guys are right! Same with the wagon - I'll lift the front and get under there and check it out. I'll post what I find. Thanks again and any other ideas are more then welcome.. Gary
Well ladies and gentlemen, - and men maybe - it appears that the result are in and the leak is caused by...........*drum roll* ...... the dip stick tube seal! That's the good news. The bad news is that it looks like I will have to either remove the exhaust or pull the transmission to get at it. I can't see up in there and I can barely get my index finger in totouch the bottom of the tube but the leakage is from that front corner of the tansmission body and not from the front seal as I had expected. I'll have to get back under there and really do some poking around but either way, it's not promising to be as easy as one would think or hope for. *sighs* Having said that, I really do appreciate the input and the time that everyone took to share your thoughts. Thank you.
Don't give up too quick on getting that tube outathere. They are all very tight but you can usually change them without pulling much. If its really tight try jacking the tranny up and take out the mount thus lowering the back of it a bit-- may have to pull the driveshaft but maybe not ?? You might have to raise it rather than lower it too. You can sometimes pull the motor mount thru bolt and move that end around a bit too. If you had a GM,THere is a tube available with a lip seal... seems to me its pn 1400 something 0003 ?? Carl 2 might know it and a lip seal change up and it might fit a C6, or maybe Ford has one similar??. Try looking up a TH350 tube outa a 1980 gmc and you can cut the end off and braze it onto the rest of your existing tube if it doesnt fit, and that is a much better seal than you will ever get with an O-ring. I can get the PN if you need. I did this on the camino and it fit , just had to lopp the top end off cause is was long & i threw that chrome piece of SHHHt tube over the shoulder !
-- Edited by Elroy on Friday 12th of June 2009 03:28:21 PM