Enjoy 5% OFF at VEVOR Canada! and Support Canadian Poncho at the Same Time!
Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: Control arm bushing. Replacement question?


Canadian Poncho Superstar!

Status: Offline
Posts: 10567
Date:
Control arm bushing. Replacement question?


Question.

Can 65-70 full size front upper control arm bushings be replaced "in car".
Can I change them without popping the upper ball joint, and potentially damaging it's seal?

-- Edited by cdnpont on Thursday 18th of March 2010 09:26:52 PM

__________________
65 Laurentian post, 67 Grande Parisienne 4 door HT. 
 


Canadian Poncho Superstar!

Status: Offline
Posts: 4525
Date:

I've replaced these bushings several times; and also had them replaced by shops. In all cases the control arm had to be out of the car to enable the new ones to be gradually pressed in. I used a hydraulic jack against a fixture.

To get the ball joints out of the spindle without damage I have had success with a homemade tool consisting of large long bolts with deep (3") nuts. I turned the bolt against the tip of the upper ball joint (with nut off the top ball joint), using the fixed and jack-supported lower control arm to screw against.  

__________________

62 Catalina 2 dr post project

55 Bel Air 2 dr post 265PP/PG

68 Bel Air 2 dr post BB project

 

Nov 18 to Dec 2 Black Friday UP TO 50% OFF Plus Huge Coupons
Nov 18 to Dec 2 Black Friday UP TO 50% OFF Plus Huge Coupons


Canadian Poncho Superstar!

Status: Offline
Posts: 10567
Date:

Good idea about the homade jackbolt. I'd never have thought of that.
I've done bushings on the bench before. No biggie there.

Given that the space is tight in the area of the bushing and shaft, I'll just pull the arms. Dumb to even consider it. I actually have a spare set of arms and some TRW ball joints. Maybe I'll just "pre build" a set of arms and do it all in a day.

__________________
65 Laurentian post, 67 Grande Parisienne 4 door HT. 
 


Canadian Poncho Superstar!

Status: Offline
Posts: 7183
Date:

The jack bolt is a great idea, once you have it 'loaded' a few beefy taps with your blacksmith hammer,,and it should go 'pop'

I love sound effects...

__________________

later...rog

AADD supporting member !!
I'm a collector...not a builder!!Located in sunny central Saskatchewan at the lakehead!
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us
.
Support Canadian Poncho!
Select Amount:
<
.
.
.