I have just installed a Front Disk conversion and replaced all my brake lines. I bench bled the master cyl and now want to do the rest with out a motor to supply vacumn will pedal pressure still work?? Or shoul a just do a gravity "bleed" starting with Pass rear. I tried to bleed the master on the bench but di not knowi was supposed to seperate it from the Vacumn part I do not want ot buy a fancy pump system unless it is neccesary. Thanks
I have had very good success using a suction gun on the bleeder screws on the rear wheels. Usually I've found the fronts will pretty much come in by themself but a suction gun would surely do it for them if not.
As far as not running, it still should work.
__________________
1966 Strato Chief 2 door, 427 4 speed, 45,000 original miles
1966 Grande Parisienne, 396 1 of 23 factory air cars (now converted to a "factory" 4 speed)
Also, I pull slowly on the gun and as soon as I see fluid enter the clear hose, I stop. I am not sure the plunger material in the gun is compatible with brake fluid.
__________________
1966 Strato Chief 2 door, 427 4 speed, 45,000 original miles
1966 Grande Parisienne, 396 1 of 23 factory air cars (now converted to a "factory" 4 speed)
