2024 Canadian Poncho Calendars are Now Available! CLICK HERE

 

 

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: Has anyone installed a modern day F.I. with an in tank pump ?


Uber Guru

Status: Offline
Posts: 3986
Date:
Has anyone installed a modern day F.I. with an in tank pump ?


Looking into doing that in regards to wiring an in tank pump. Thinking a FiTech unit for the carb replacement.

 

Have you put a relay to control it ? How did you wire it ?



__________________

Remember Fun,

 Remember Laughter ?



Poncho Master!

Status: Offline
Posts: 2190
Date:

I put FiTech into my 350 crate and found out that the tank was not deep enough for the recommended pump
An auxiliary pump was installed on the firewall.
Makes lots of noise.
The repair shop in Markham did the installation.
Comes with a gadget to fine tune the carb settings
Havent bothered to play with it.
Starts much better.


__________________

Cliff

Done Hurryin

Like the larger type for my eyes. 

 

 



Addicted!

Status: Offline
Posts: 177
Date:

I just installed one of these into the tank in my Holden HK GTS for a Holley Sniper setup. These are Australian but you will be able to get similar stuff in Canada. If you can't the MRA units listed in that site for VT-VY will be the same as the Australian made Pontiac GTO sold in North America around 2003-6, and the VE MRA will be the same as Pontiac G8 and Chevrolet SS sedan plus maybe even the 5th gen Camaro that was based upon the VE Holden. If you can't get the weld in rings in Canada you could order that kit from Australia and buy the MRA in Canada or the USA. Which MRA you use depends upon the height of the tank, the MRA base is spring loaded so has to push against the flat bottom of the tank once bolted in.

You an run those bolt on EFI setups as either return to tank with a regular in the throttle body or after it, or dead head them in which case the MRA has an inbuilt regulator. Just buy the right MRA.

I used a VT-VY style, with an MRA from a VZ Holden (which will be the same as the final Pontiac GTO) as I am dead head feeding the Holley Sniper - the regulator is in the MRA. If you want that height MRA and want to run a return line use the VT MRA.


www.efihardware.com/products/c471/Fuel-Tank-Conversion-Kits



-- Edited by HK1837 on Wednesday 8th of September 2021 08:52:05 PM

__________________


Addicted!

Status: Offline
Posts: 412
Date:

Im following this thread.

With a bit of a search, Summit carries a generic in-tank fuel pump setup but I would like to hear from someone that has done an install, what they used and what they think of the result. My Nova has the fuel lines required so it would be my first attempt. If it works out, the Beaumont would be next. Interested to hear about experiences anyone has had.

Carl has a guy for this, but I would like to do as much preliminary work as I can and leave it to the expert to finish the install and drive it home. As I proof-read this, talking to Carls contact might be the best approach!



__________________

72 Nova SS,   66 Beaumont Sport Deluxe,   09 Pontiac Solstice GXP Coupe



Addicted!

Status: Offline
Posts: 401
Date:

Added Holley Sniper EFI to the Beau. Ended up sourcing the replacement tank/pump from them, too. Happy to hook anyone up with my friend, who did the heavy lifting on the install. He's a wizard with electrical and electronic stuff, the physical part of the installation was pretty much bolt-in, and bolt-on, the art is in hooking up the juice, and in programming the EFI's ECU. Once it was running, I had it dialed in on a chassis dyno. It's still "learning", I'm just not using the car enough.

__________________

see2xu

66 Beau 2DHT 427FI, 700R



Veteran Member

Status: Offline
Posts: 25
Date:

Installed Sniper on 327. Used Holley OEM tank module on stock gas tank. Works great and eliminates return line. Quieter. Cooler. Recommend. Relay in Sniper harness. Includes power wire lI got enough. just had to run a ground. I ran it all the way back to battery. 



-- Edited by Paddycanuck on Friday 10th of September 2021 06:12:24 PM

__________________
Paddy O'Flynn


Poncho Master!

Status: Offline
Posts: 2190
Date:

I was told the more you drive it  the more it learns about your driving style and adjust as it goes.

With my medical suspension of my license I haven't been able to put on many miles.

 

 



__________________

Cliff

Done Hurryin

Like the larger type for my eyes. 

 

 



Uber Guru

Status: Offline
Posts: 3986
Date:

I got a new tank with an integral pump from RockAuto. GM37EFI
Im more concerned with the with wiring of it.

__________________

Remember Fun,

 Remember Laughter ?



Addicted!

Status: Offline
Posts: 177
Date:

There should be manuals and wiring diagrams with the system you buy. Holley Sniper does, here is the Sniper Quadrajet full manual:

For some reason it won't let me put the link in. The resources are here:

https://www.holley.com/support/fuel_injection/sniper_efi/

 



-- Edited by HK1837 on Saturday 11th of September 2021 12:55:47 AM

__________________


A Poncho Legend!

Status: Offline
Posts: 48633
Date:

https://www.holley.com/support/fuel_injection/sniper_efi/

 



__________________

1966 Strato Chief 2 door, 427 4 speed, 45,000 original miles 

1966 Grande Parisienne, 396 1 of 23 factory air cars



Poncho Master!

Status: Offline
Posts: 1703
Date:

well. I have jumped back on at the right time. I installed an aeromotive phantom fuel pump system perfectly adaptable to your tank. Works like a charm. I access it through a cover in the boot. Has all you need. Best thing I have ever did. Recently replaced my edelbrock proflo 1 with a FAST EZI 2 retrofit kit. They come in various GPH depending on horsepower. I actually have a dual one sitting on my shelf which i got real cheap does up to 1000hp. Was going to put it in mine but decided it was overkill and left my single pump in. Running 450-500hp big block. BEST INVESTMENT EVER! and run a return system, seperate quality regulator too, I run an aeromotive, delete the built in one.

https://aeromotiveinc.com/product/phantom-340-stealth-fuel-system/

 



-- Edited by koolconvertible on Sunday 12th of September 2021 03:13:54 AM



-- Edited by koolconvertible on Sunday 12th of September 2021 03:31:01 AM



-- Edited by koolconvertible on Sunday 12th of September 2021 03:31:43 AM

__________________

cutting a roof off a four door is NOT a convertible.....

65 Parisienne convertible.one of 49 built for RHD export market,402BBC, T400, 2500 stally, posi rear, upgraded brakes with front discs, FUEL FAST efi custom built by me.

Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us
.
Support Canadian Poncho!
Select Amount:
<
.
.
.