Enjoy 5% OFF at VEVOR Canada! and Support Canadian Poncho at the Same Time!
Members Login
Username 
 
Password 
    Remember Me  
Canadian Poncho Homepage -> Canadian Poncho -> 65-70 Full Size Power Train Tech Forum -> Broken Flywheel inspection cover bolt on 396 / TH400
Post Info TOPIC: Broken Flywheel inspection cover bolt on 396 / TH400
68 Grande


Guru

Status: Offline
Posts: 827
Date:
Broken Flywheel inspection cover bolt on 396 / TH400
Permalink  

I have a broken bolt head for my flywheel inspection plate.  The inspection plate sits up nicely and tight except the one corner (top drivers) but so far has not caused any issues however I know its broke and it bugs me.  The bolt is broke off flush with the surface and I have thought about drilling it and get an easy out but that bolt is a tiny little bolt so I just have been procrastinating to do something about it. 

Anyone else happen to experience a broken bolt in this area and willing to share your experience in removing the little irritating bolt?



__________________

Now appearing as "68 Grande" 
4SPEED427


A Poncho Legend!

Status: Offline
Posts: 49872
Date:
Permalink  

Way back when I had a trans with that bolt broken. Someone had just drilled the hole bigger and put a bolt and a nut but if you are careful you could likely get it drilled out. If not, you could always rethread it to one size bigger.

If the weather was better it would be a good hoist job at our place tomorrow!

__________________

1966 Strato Chief 2 door, 427 4 speed, 45,000 original miles 

1966 Grande Parisienne, 396 1 of 23 factory air cars (now converted to a "factory" 4 speed)
Fall into savings UP TO C $50 OFF Shop now
Fall into savings UP TO C $50 OFF Shop now
65wagon


Poncho Master!

Status: Offline
Posts: 2115
Date:
Permalink  

I use the weld on washer trick with ali, works slick



__________________
seventy2plus2


Canadian Poncho Superstar!

Status: Offline
Posts: 7707
Date:
Permalink  

I'd get a real accurate center punch (possibly a spring loaded one) and dimple in the middle of the bolt. Get some left hand drill bits, and drill it to possibly get in an easy-out to extract the bolt.

I broke the screw that holds my choke thermostat in my LS6 intake, and got it out with that method, and I think that was a #10 screw. I couldn't turn the easy out, but when I moved up to the next size left hand drill bit, it bit into the screw and spun it out.

__________________
70 2+2 convertible
70 2+2 hardtop
70 Parisienne hardtop

 

 
Brian


Addicted!

Status: Offline
Posts: 437
Date:
Permalink  

If all of the above fail put a heilcoil in back to the original size.
I had to do this with my power glide.


__________________

Surrey, BC
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.
Canadian Poncho Homepage -> Canadian Poncho -> 65-70 Full Size Power Train Tech Forum -> Broken Flywheel inspection cover bolt on 396 / TH400
Tweet this page Post to Digg Post to Del.icio.us
.
Support Canadian Poncho!
Select Amount:
<
.
.
.